KX +1 20" Slimline Carbon Block

MATRIKX® + 1

Extruded Activated Carbon Block Filter

The Chlorine Taste and Odor Guzzler

• 0.6 ìm Nominal Filtration

• High Chemical Adsorptive Capacity

• High VOC Reduction

• Performance Tested and Verified by

Independent Laboratory Testing

MATRIKX® +1 provides comprehensive control of chlorine taste and odor.

MATRIKX® +1 offers: 0.6 ìm nominal filtration with extended life as a fine sediment and silt control filter, comprehensive removal of chlorine taste and odor and chemicals that contribute to taste and odor, and high VOC reduction capacity.

The service life of MATRIKX® +1 filters is greatly extended by a prefiltration medium. The MATRIKX® +1 is ideal for use in residential and commercial water purification systems, industrial effluent water treatment, food service, industrial makeup, product rinse, process water, and pre - and post-RO systems which require nearly absolute chlorine taste and odor reduction.

Part No.:01-250-125-20

Length:2.50” x 20”

Weight:1.75 lbs.

Reduction Capacity @ Flow:>45,000 gal. @ 2.3 GPM

Micron Rating Reduction 0.6 ìm

Chloroform Reduction: 1750 gal. @ 1.2 GPM

Inital filter differential pressure loss: 3.0 psid @ 2.0 GPM

ORDER INFORMATION Special order filters are available in varying sizes with lengths from 1” to 60”. Standard filters are finished with a prefiltration medium. A protective polypropylene netting is applied to the exterior of the cartridge. Polypropylene end caps with compression gaskets fit most standard housings. Inquire concerning alternative filter finishing options, including alternative end cap and housing interface styles, a wide range of non-standard extruded filter sizes, and non-standard prefiltration systems. EXTRUDED CARBON = EXCEPTIONAL VALUE MATRIKX® + 1 filters consist of activated carbon particles fused into a uniform block with enhanced adsorptive capacity and efficiency. MATRIKX® + 1 filters flow in a radial (outside-to-inside) direction, providing increased dirt-holding capacity and low pressure drop. Unlike granular activated carbon (GAC) filters, MATRIKX® + 1 cartridges will not channel or bypass due to the extreme uniformity of their extruded activated carbon core. Service life of the MATRIKX® + 1 filter is greatly extended by a prefiltration medium.

• No channeling

• No fluidizing

• No bypassing

• Eliminates release of carbon fines

• Lowest extractables, pure materials of construction

• Maximum service life and resistance to fouling

• Graded density prefiltration design

• Manufactured using FDA-compliant materials

NOTES

1. Performance of a given MATRIKX® extruded carbon filter varies in direct proportion to the total weight of carbon in each filter. For example, a 4.25” O.D. x 20” L MATRIKX® filter contains approximately seven times as much activated carbon as a 2.50” O.D. x 9.75” L MATRIKX® filter, and will therefore have seven times the rated chlorine taste and odor capacity when operated at seven times the rated flow of the smaller cartridge. Hence, rated flow is based on maintaining identical contact/residence times for all filters.

2. Projected chlorine taste and odor reduction capacity when tested in accordance with NSF/ANSI Standard 42 protocol.

3. Nominal particulate rating (0.6 ìm) is for >85% of a given size as determined from single-pass particle counting results.*

4. Absolute particulate rating (2 ìm) is for >99.9% of particles of a given size as determined from single-pass particle counting results.** *Nominal Filter Rating: Filter rating indicating the approximate size particle, the majority of which will not pass through the filter. It is generally interpreted as meaning that 85% of the particles of the size equal to the nominal micron rating will be retained by the filter. (WQA Glossary of Terms, Third Edition, 3-97). ** Absolute Filter Rating: Filter rating meaning that 99.9% (or essentially all) of the particles larger than a specific micron rating will be trapped on or within the filter. (WQA Glossary of Terms, Third Edition, 3-97). WARNINGS:

Maximum Operating Temperature: 125°F

Maximum Operating Pressure: 250 psig

Maximum Differential Pressure: 100 psid

Collapse Pressure: 200 psid

MATRIKX® + 1 filters are not to be autoclaved or steam-sterilized.

Use MATRIKX® + 1 carbon filters only with microbiologically safe and adequately disinfected water. Activated carbon filters are not designed to kill or remove bacteria or viruses.

Actual results obtained will vary with various combinations of organic contaminants, changes in pH or other conditions encountered in actual use. All information presented here is based on data believed to be reliable. It is offered for evaluation and verification.