3/4" HD Compact Motorized Ball Valve - 110 VAC

General Specifications
• Maximum operating pressure: 150 psi (1055 kPa)
• Operating temperature range: 40-150•F (5-65•C)
• Standard valve body: Bronze; also available in stainless steel for added corrosion/abrasion resistance
• Cast-aluminum actuator housing
• Stainless steel ball with teflon seat
• Single phase induction motor; 115 VAC; 1.8 ampere (For 220 VAC installation, an external transformer is available, when specified, at an additional cost)

Installation, Operation & Programming

Installation
refer to the image above

Proper Wiring
Terminal #1 - To power supply
Terminal #2 - To power supply
Gr. - Ground
Suitable conduit is recommended.

Operation
This valve functions according to two distinct operations:
Cycle Time • How often the valve shall open
Purge Duration • How long the valve is open for purging The integral timer triggers the actuator to open and close as programmed (see below). Interruption of power will cause the timer to reset. When power is restored, the valve will open for its programmed duration and begin its programmed cycle time.

Programming Cycle time and purge duration are set by arranging a series of small switches. These switches are located within the actuator housing, accessible by removing the housing cover.
CAUTION:
Disconnect/interrupt power to the actuator before removing cover to program the valve.

Instructions for programming the switches are labeled inside the actuator housing and noted on reverse for your convenience. Once the switches have been set, be sure to re-attach the actuator housing. Note the o-ring for protection against moisture and dust.

To manually open the valve for purging, press and hold the external button on the actuator housing. Valve will open for the programmed purge duration and begin a new cycle, as programmed.

Sand Separators

3/4"

Sand Separators

3/4"