Skid Mount Complete Commercial Reverse Osmosis

STANDARD ELECTRICAL CONTROLS:
Off/On switch
TDS monitor
Motor contactor
Time delay
Fused power
System control switch
Off delay
Low pressure switch
Low press. off delay
Dual level controller (R.O.)
NEMA 4 fiberglass enclosure

STATUS LAMPS:
power, running, low pressure, tank full

POWER REQUIRED:
1. 220v/ 60hz, 17 amp, 1• and
2. 120v / 60hz, 5 amp


FEED WATER PARAMETERS:
Temperature 85o F maximum
Pressure 40 - 80 psi maximum
TDS 2000 ppm maximum. If higher, consult factory
Iron tolerance 0.5 ppm maximum
Hydrogen sulfide must be removed
Silica tolerance can not be higher than 125 ppm in the concentrate stream. Antiscalant should be considered for any levels over 75 ppm.
Turbidity should be removed
Hardness must be removed


OPERATING PARAMETERS:
Operating pressure 200 psi maximum
Water recovery up to 60% and is field adjusted by customer. It is not recommended that the recovery be set higher than 50%. Only under certain conditions can the recovery be set higher.
pH range 3 - 11
Flow rates are determined by the membrane mfgr.s. testing criteriea of 1500 ppm Nacl solution, 77oF water temperature, 225 psi at 10-15% recovery. Typical membrane salt rejection is 95.99%

*Actual flow rates may vary depending on the pre-treatment used, water conditions, feed water temperature and applied pressure, etc.

Reverse Osmosis

Usually ships in 2-3 weeks

Reverse Osmosis